4
5. Installation & Operation
Please refer to Fig. 1, Fig. 2, or Fig. 3 (Pg2 & Pg3) and setup guide
below:
1. Connect the video output (1) to the monitor or other video device
through a 75 ohms type coaxial cable.
2. Connect the power source (2) with either an AC power adapter
or a DC jack (+12V DC is in the jack center), then the LED
indicator (3) will light.
3. Once the picture appears on the monitor, open the cover (4)
adjust the lens wrench of “WIDE
←→
TELE” (5) to get the view
angle that you desire, then adjust the focus wrench (6) of the
lens to obtain the best picture.
4. Tighten this two wrench(5, 6) both, then put the cover (4) back.
5. Mount the camera on the mounting bracket by using the hole (7)
on the top or bottom of the camera or using the enclosed 8mm
mounting block (2 screws included).
6. DIP Switch (8) Setting
•
BLC
FUNCTION
Set switch-OFF/BLC to BLC to enable back light compensation
(BLC) function.
•
AUTO IRIS FUNCTION
When using an auto iris lens, the switch-AES/OFF should be
in the OFF position to disable the AES function.
7. Adjust the LEVEL with the VR (9) to proper level.
8. Optional audio function (10).
