5
6. Installation & Operation
Please refer to Fig. 1 or Fig. 2 (P3 & P4) and setup guide below:
1. Connect the video output (1) to the monitor or other video device
through a 75 Ohms type coaxial cable.
2. Connect the power source (2), AC with the power cord, or DC by
using the DC Jack (+12V DC is in the center of the jack plug),
then the LED indicator will lit.
3. Once the picture appears on the monitor, open the cover (4) adjust
the lens wrench of “WIDE
←→
TELE” (5) to get the view angle that
you desire, then adjust the focus wrench (6) of the lens to obtain the
best picture.
4. Tighten the two wrench (5) and (6), then put the cover (4) back.
5. Mount the mounting bracket to hole (7) on the top or bottom of the
camera, using the enclosed 8mm mounting block with 2 screws
furnished.
6. DIP Switch (8) Setting
•
BLC FUNCTION
Set Switch-OFF/ BLC to BLC to enable Back Light Compensation
(BLC) function.
•
AUTO IRIS FUNCTION
When using an Auto Iris Lens, the Switch-AES/ OFF should be
set to OFF, to disable the AES function. Adjust the VR LEVEL (9)
to the proper level.
•
AGC-Hi / AGC-Lo Function
This switch setting to High or Low of the AGC maximum gain.
•
Flickerless Function
Set switch-OFF/FLON to FLON to enable flickerless function, in
this mode, the switch-AES/OFF is auto disabled.
•
AES Function
When using the lens (other than Auto Iris Lens), the Switch-AES/
OFF should be set to AES.