background image

12

Distributed by

AUSTRALIA
Brown & Watson International Pty. Ltd.

Knoxfield Victoria 3180
Phone: (03) 9730 6000
Fax: (03) 9730 6050
National Toll Free: 1800 113 443

NEW ZEALAND OFFICE
Griffiths Equipment Ltd.

19 Bell Avenue, 
Mount Wellington, 
Auckland 1060, New Zealand
Phone: (09) 525 4575 
Fax: (09) 579 1192

IS494

Issue 2  7.10.2021

WARRANTY STATEMENT

Brown & Watson International Pty. Ltd. (“BWI”) of 1500 Ferntree Gully Road, Knoxfield, Vic., 
telephone 1800 294 294, warrants that all products described in its current catalogue will under 
normal use and service be free of failures in material and workmanship for a period of three (3) year 
from the date of the original purchase by the customer as marked on the invoice (see elsewhere for 
specific warranty period). This warranty does not cover ordinary wear and tear, abuse, alteration of 
products or damage caused by the purchaser.
To make a warranty claim the consumer must deliver the product at their cost to the original place of 
purchase or to any other place which may be nominated by either BWI or the retailer from where the 
product was bought in order that a warranty assessment may be performed. The consumer must also 
deliver the original invoice evidencing the date and place of purchase together with an explanation in 
writing as to the nature of the claim.
If the claim is determined to be for a minor failure of the product then BWI reserves the right to 
repair or replace it at its discretion. If a major failure is determined the consumer will be entitled 
to a replacement or a refund as well as compensation for any other reasonably foreseeable loss or 
damage.
This warranty is in addition to any other rights or remedies that the consumer may have under State 
or Federal legislation.

IMPORTANT NOTE

Our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You 
are entitled to a replacement or refund for a major failure and compensation for any other reasonably 
foreseeable loss or damage. You are also entitled to have the goods repaired or replaced if the goods 
fail to be of acceptable quality and the failure does not amount to a major failure.

Summary of Contents for Projecta PMDC-30













Reviews: