TAYO ZONTES 310T-M 2022, Maintenance Manual

Page: 42 / 188

42 / 188
●If you need to remove the muffler for other operations, it is
recommended to cover the air inlet and outlet holes of the
muffler with textured paper to prevent foreign objects from
entering.
●Keep the drain hole at the bottom of the muffler unblocked
to prevent condensation water from accumulating in the
muffler cavity.
●Clean up the dirt, dirt and other stains on the surface of the
muffler in time.
M310 Spark plug
Caution:
●Be fore disassembling, blow off the dust near the spark plug
with a dust blower.
●After removing the spark plug, prevent foreign objects from
falling into the engine.
1. Disassemble the spark plug
a. Put down the left rear pedal and use the 4# inner
hexagon to remove the M6
×
14 bolts.
b. Pull out in sequence in the direction of the arrow (from
the rear wheel to the front wheel). Note that there are 5
staples at the red circle and a circle of buckles around. It
takes a lot of force to pull out.
c. Use your fingers or a plastic crowbar to insert the arrow
indication point, first pry the arrow indication point open the
gap and then pull up.
d. Respectively use 4# inner hexagon to remove the 2 M6
×
12 bolts at the front pedal.
e. Use 4# inner hexagon to remove the 3 M6
×
14 bolts
that surround the left side(1).
f. Use your fingers or a plastic crowbar to forcefully break
out from the arrow point until the bolt near the arrow point
is exposed. Because there are still bolts on the upper part
that have not been removed, it cannot be removed directly.
g. Use 5# inner hexagon to remove M6
×
14 bolt, then
remove bushing.