Quality Wooden Children’s Furniture and Accessories
Toy Stoprage Chest Assembly Instructions- Continued
•
Insert a
Barrel Nut
into the
Back
panel
Barrel Nut hole in relation to the Joint
Connector Bolt previously installed.
•
Make sure the longest slot on the head
of the Barrel Nut is perpendicular to
the Joint Connector Bolt.
•
Fasten the
Side
panel and
Back
panel
together. Start Joint Connector Bolt by hand
and after a few turns begin using the supplied
Allen wrench.
•
Make sure Back panel fits inside groove.
Tighten bolt to a snug fit. Then unscrew one
full turn to allow adjustment.
•
Now, repeat steps 1,2 and 3 for
second hole and to assemble
the other
Side
panel.
•
Starting with a
Side
panel,
insert
one
Joint
Connector Bolt
in Joint Connector Bolt
hole.
•
Repeat steps 1, 2 and 3 to attach
Front
panel to body.
•
With the box sitting flat on a hard
surface, tighten all eight bolts.
Bottom Panel
Panel Groove
1
2
3
4
5
6
Page 2 of 3
•
Using the existing holes, attach bottom of
Lid Support
to inside of Back with 2
#8
screws
•
Be careful not to over tighten screws.
•
Place
Lid
on top of the box and line
up existing holes located on outside
of the back panel to holes in hinge.
Attach hinge to back of box using 14
#5
screws.
•
Be careful not to over tighten screws.
Lid
Body
Back
Lid Support
Partial view of Back/Front panel
Barrel Nut Holes
Joint Connector
Holes
Side Panel
Top
Bottom
Area of Detail
Made in America
•
Now that you have the two sides
fastened to the back; slide the
Bottom
panel in the bottom grooves
(The side with the logo is the top
side).
