OPERATING PROCEDURES
6-9
087482-M
Operating Procedures
6
3.
Lubricate the O-rings on the air tube on the end with
the small hole on the side.
4.
Install the air tube (the end with the hole) with the air
orifice installed into the mix inlet hole in the mix
hopper.
5.
Press the AUTO key. The AUTO light will come on,
indicating the main refrigeration system is operating.
When the unit cycles off, the product will be at
serving viscosity.
Figure 6-31
Note:
The MIX REF light will come on, indicating the mix
refrigeration system is operating to maintain the mix in
the mix hopper.
6.
Fill the hopper with mix. As the mix level comes in
contact with the mix level sensing probe on the rear
wall of the hopper, the MIX LOW light will shut off.
7.
Place the mix hopper cover in position over the mix
hopper.
8.
Repeat step 1 through step 7 for the other side of the
freezer.
Closing Procedure
To disassemble these units, the following items will be
needed:
•
Two cleaning pails
•
Sanitized stainless steel rerun can with lid
•
Necessary brushes (provided with machine)
•
Cleaner
•
Single-service towels
Draining Product from the Freezing
Cylinder
1. Press the AUTO key to cancel operation. Press the
MIX REF key to cancel hopper refrigeration. These
operations should be canceled as far ahead of
cleaning time as possible to allow frozen product to
soften for easier cleaning.
Remove the mix hopper cover and feed tube from the
machine. Take them to the sink for cleaning.
2. If local health codes permit the use of rerun, place a
sanitized NSF-approved stainless steel rerun
container beneath the door spouts. Press the WASH
key and open the draw valves. When all the product
stops flowing from the door spouts, close the draw
valves and press the WASH key to cancel the wash
mode. Place the sanitized lid on the rerun container
and place it in the walk-in cooler.
Note:
If local health codes do not permit the use of
rerun, the product must be discarded. Follow the
instructions in the previous step, except drain the product
into a pail and properly discard the mix.
3. Repeat
step 1 and 2
for the other side of the
machine.
Rinsing
Note:
Do not brush clean the mix inlet hole while the
machine is in the WASH mode.
1. Pour 1 gal. (3.8 L) of cool, clean water into the mix
hopper. With the brushes provided, scrub the mix
hopper and the mix inlet hole.
2. With a pail beneath the door spout, raise the prime
plug and press the WASH key.
3. When a steady stream of rinse water is flowing from
the prime plug opening in the bottom of the freezer
door, open the draw valve. Drain all the rinse water
from the door spout. Close the draw valve, push the
prime plug down, and press the WASH key
cancelling the WASH mode.
Repeat this procedure until the rinse water being
drawn from the freezing cylinder is
clear
.
4. Repeat step 1 through step 3 for the other side of the
machine.
30227_A
!
ALWAYS FOLLOW LOCAL HEALTH CODES.
Summary of Contents for C791
Page 8: ...1 4 TO THE INSTALLER 087482 M To the Installer 1 ...
Page 38: ...9 2 PARTS REPLACEMENT SCHEDULE 087482 M Parts Replacement Schedule 9 Notes ...
Page 42: ...10 4 LIMITED WARRANTY ON EQUIPMENT 087482 M Limited Warranty on 10 Notes ...
Page 46: ...11 4 LIMITED WARRANTY ON PARTS 087482 M Limited Warranty on Parts 11 Notes ...
