Taylor C152, Service Manual, Page: 33 / 88

TROUBLESHOOTING
3-3
Model C152 & C161
Troubleshooting
3
7. Excessive mix
leakage from the
bottom of the door
spout.
a. The bottom O-ring on the draw valve is
improperly lubricated or worn.
a. Lubricate properly or replace the O-ring.
8. Excessive mix
leakage into the long
drip pan.
a. The seal on the drive shaft is improperly
lubricated or worn.
a. Lubricate properly or replace the seal.
b. The seal is installed inside out on the drive
shaft.
b. Install the seal correctly.
9. Excessive mix
leakage from the rear
of the freezer into the
short drip pans.
a. Worn or missing O-rings. a. Install or replace the O-rings.
b. Inadequate lubrication of the drive shaft. b. Lubricate properly.
c. The drive shaft and beater assembly work
forward.
c. Verify the refrigerant charge and check for a
shorted freezing cylinder.
d. Worn rear shell bearing. d. Replace the component.
e. Gear box out of alignment. e. Re-align the gear box.
10. The drive shaft is
stuck in the drive
coupling.
a. Mix and lubricant have collected in the drive
coupling.
a. Brush clean the rear shell bearing area
regularly.
b. Rounded corners of the drive shaft, the drive
coupling, or both.
b. Replace worn component(s).
c. The gear box is out of alignment. c. Re-align the gear box.
11. Freezing cylinder
walls are scored.
a. Missing or worn front bearing. a. Install or replace the front bearing.
b. The beater assembly is bent. b. The beater assembly must be replaced.
c. The gear box is out of alignment. c. Re-align the gear box.
12. The machine will not
run when in the Auto
mode.
a. The machine is unplugged. a. Plug into wall receptacle.
b. The beater motor is out on reset. b. Allow the beater motor to cool. Place the
power switch to the OFF position. Press the
RESET button firmly. Place the power
switch to the ON position, and press the
Wash button. Open the side access panel
and observe that the drive shaft is turning
clockwise as viewed from the front of the
machine. Press the Auto button to return to
the Auto mode.
c. Do not use metal objects to press the
RESET button.
c. The circuit breaker is off, or the fuse is blown. d. Turn the breaker on, or replace the fuse.
d. Low on mix. The Mix-Out light is on. e. Add mix to the mix hopper and press the
Auto button.
e. Water-cooled machines: The water is turned
off.
f. Turn the water on.
13. Product is not feeding
into the freezing
cylinder.
a. The mix inlet hole is frozen up. a. The hopper temperature needs adjustment.
b. Incorrect usage of the mix feed tube. b. Follow the correct feed tube procedures and
use of the air orifice.
Problem Probable Cause Remedy