Step 8: (cont.)
Repeat this procedure for each of the straps on both sides
of the front section of the enclosure and on the back
section - these will all be the shorter straps - keep fabric
tight and evenly centered over the playpen on the boat.
Note: If possible, do not install strap/snap into the frame
of entry doors on the boat.
Step 9:
At each of the two stern corners on the outside of the enclosure, you will find an adjust-
able buckle and sewn-in strap that run parallel to the bottom outside edge of teh enclosure.
These straps allow the fabric to be tightened or loosened at the radius of the frame corners,
to fit properly. Position the end of the webbing into the adjustable buckle and snug to
tighten up fabric from the sides to the rear of the enclosure.
Step 10:
In the front section of the enclosure, zip closed
both sides of the entry way door. The sides are
designed to drape around the interior seating on
your boat. The bottom edges have the adjustable
buckles and webbing snap/strap assemblies;
designed to secure to any convenient location
on the base of the seats or back to the bottom
of the playpen railing base. Use the two longer
strap assemblies as necessary, depending on
what snap locations are available. Determine the
best location for the installation of the male
self-tapping snaps for your applications.These locations should keep the bottom of the enclosure straight and taut, without
putting undue stress on the entry way door zippers. It is best NOT to install the snaps directly onto the deck of the boat.
The initial assembly of your Pontoon Enclosure is now complete. Note that the windows and doorway can be rolled up and
out of the way when desired - held in place with Hook & Loop straps.
To remove enclosure for storage or when your boat is underway, simply follow these easy steps:
• Unhook the snaps around the perimeter of the enclosure-leave the webbing in the buckles “as is” for ease of re-installation.
• Release the Hook & Loop fasteners from around the poles on the underside.
• Remove the center (3-Section) pole from the underside of the enclosure - disassemble and fold up pole sections.
• Pull the top down off the three main frame poles - fold up and place aside (for long term storage - never pack up a wet
or damp Top).
• Gently pull one end of one pole from the
mounting bracket - gently allow the pole to
straighten out. BE VERY CAREFUL AS YOU
MANUVER THE POLE - IT WILL FLEX
BACK STRAIGHT VERY QUICKLY IF
NOT HELD SECURELY. Disassemble and
fold up the pole sections. Repeat for the second
and third 8-Section pole.
• A convenient storage bag has been provided for your Pontoon Enclosure.
TAYLOR MAKES NO EXPRESS OR IMPLIED WARRANTIES OTHER THAN WARRANTIES SET FORTH HEREIN, INCLUDING, WITHOUT LIMI-
TATION, THE WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE, OR FROM ANY COURSE OF DEALING OR
TRADE USAGE.
TAYLOR SHALL NOT BE LIABLE FOR SPECIAL, INDIRECT, INCIDENTAL, PUNITIVE OR CONSEQUENTIAL DAMAGES, INCLUDING, WITH-
OUT LIMITATION, DAMAGES FOR LOSS OF OPPORTUNITY OR BUSINESS PROFITS, BUSINESS INTERRUPTION OR ANY OTHER LOSS
EVEN IF TAYLOR HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.
IN NO EVENT SHALL TAYLOR BE LIABLE FOR ANY AMOUNT IN EXCESS OF THE PURCHASE PRICE PAID.
ADDITIONAL WARRANTY INFORMATION
Taylor Made Products
65 Harrison Street
Gloversville, NY 12078
Made in China
A Member of The Taylor Made Group
www.taylormadeproducts.com
®Taylor Made is a registered trademark of the Nelson A. Taylor Co., Inc.
