![background image](http://html1.mh-extra.com/html/taylor-made/aquafi-781414/aquafi-781414_installation-and-owners-manual_3755446003.webp)
3
taylormadeproducts.com/aquafi
574-534-7521
Rev:08.01.19
AquaFi
™
Installation and Owner’s Manual
(For Aftermarket Applications)
CCD-0002558
Fig.2
A.
If necessary, use wire strippers to expose enough
bare wire to make a good electrical connection within the
butt connector�
B.
Cut a 1
1/2
” long strip of heat shrink tubing� Slip tubing
onto electrical wire�
Fig.3
A
B
C.
Insert the docking wire into one open end of the butt
connector, then crimp butt connector in-place using a
crimping tool�
D.
Insert 12V DC electrical system wire into the
remaining open end of the butt connector� Crimp butt
connector in-place�
E.
Slide heat shrink tubing over the connection� Apply
heat gun to the tubing� to seal the connection�
F.
If using heat shrink/crimp butt connectors, additional
heat shrink tubing is not required� Do as follows:
I.
Insert wire into butt connector�
II.
Crimp butt connector�
III.
Repeat steps I and II on the other connector end�
IV.
Use a heat gun on the butt connector to seal it
against the electrical wires�
NOTE:
Make sure the electrical connections are secure
and protected against water�
5.
Secure the AquaFi Hotspot Dock Assembly to the
watercraft with four #8 pan head screws
(Fig.4A)
�
Fig.4
A
to watercraft
12V DC power
C
A
B
NOTE:
Mounting dock electrical wires
(Fig.3A and B)
are
6” long�