4.46
9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
11. Select the same file type from the list that you
selected previously while in Digital Wrench®. Enter
the VIN along with the customer’s name and address.
When completed, click the Authorize button
once
to
proceed.
12. An “Authorization Key” will appear in the upper left
corner of the screen. Copy this key exactly as it
appears.
13. Enter or paste the Authorization Key in the box
located on the Digital Wrench® screen. Click the
‘Continue’ button and follow instructions provided on
the screen to complete reprogramming procedure.
14. At this point the reflash process will begin. Do not
touch the vehicle or PC during the process.
15. Once
the
ECU
reprogramming
procedure
is
complete, click the ‘Finish’ button on the screen.
Verify the reflash was a success by starting the
vehicle.
ETC LEARN PROCEDURE
IMPORTANT
This procedure MUST be performed on the vehicle
whenever the ECU is replaced or reflashed or the
throttle body is replaced.
1. After the reflash / ECU replacement / throttle body
change, leave the key on (engine not running) for 60
seconds. Do NOT crank the engine during this time.
2. Turn the key off and wait 3 minutes. During this time,
the ECU will write values into memory and then
completely shut down.
3. Turn key back on and start the vehicle. The vehicle
should operate normally.
4. If the procedure was interrupted at any time, start
back at step 1.
Summary of Contents for G0-010-00
Page 60: ...2 36 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES MAINTENANCE...
Page 196: ...4 48 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES FUEL SYSTEM...
Page 224: ...5 28 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES CVT SYSTEM...