9929758 R01 - 2019 TAYLOR-DUNN G-100 Service Manual
© Copyright TAYLOR-DUNN
4.27
• If the resistance test, air gap test, and flywheel
inspection all test good, remove the flywheel and
verify the keyway is in good working order. If the
keyway is intact and problems persist, thoroughly
inspect the relevant wiring connections as a
electrical component or connection may persist.
7. Install the stator if removed (see Engine / Cooling
System chapter).
8. Install the stator cover if removed (see Engine /
Cooling System chapter).
9. Install a NEW or known good CPS. (see CPS
Replacement).
10. Fill and bleed the coolant system (see Engine /
Cooling System chapter)
CPS REPLACEMENT
1. If not done already; disconnect the CPS harness
connector.
2. Using an 8 mm socket, remove the CPS retaining bolt
and remove the sensor from the stator cover.
3. Install new sensor using a light coating of oil on the
O-ring to aid installation.
4. Torque the CPS and heat shield retaining bolts (if
equipped) to specification.
TORQUE
CPS Retaining Bolt:
9 ft-lbs (12 Nm)
Summary of Contents for G0-010-00
Page 60: ...2 36 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES MAINTENANCE...
Page 196: ...4 48 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES FUEL SYSTEM...
Page 224: ...5 28 9929758 R01 2019 TAYLOR DUNN G 100 Service Manual Copyright TAYLOR DUNN NOTES CVT SYSTEM...
