Taylor-Dunn C0-426-48AC, Service And Replacement Parts Manual

Page: 42 / 132

Steering
Page 42
C-426
MC-425-15
REPLACE STEERING SHAFT
1: If equipped with a horn switch in the steering
wheel, remove the switch, disconnect the wires
from the switch and cut the terminals off of the
wires.
2: Remove the steering wheel. Refer to Replace
the Steering Wheel procedure for information
regarding removing the steering wheel.
3: Remove the upper steering shaft bushing or
bearing from the steering column.
4: Remove the steering gear access cover from the
steering column (if equipped).
5: Remove and discard the pinch bolt and nut from
the steering shaft coupler.
Note: Most vehicle configurations will now allow
the steering shaft to slide off of the steering
gear input shaft and then back down out of
the steering column. If there is not enough
clearance for this procedure then the
steering gear must be removed. Refer to
Replace the Steering Gear for information
regarding removing the steering gear.
6: Remove the steering shaft from the vehicle.
7: Lightly grease the input shaft splines, steering
wheel splines and the upper steering shaft
bushing.
8: Install the steering shaft in reverse order using
a new pinch bolt. Orientate the shaft so that the
pinch bolt is opposite the flat in the steering gear
shaft. See the illustration to the right.
9: Tighten the pinch bolt per torque listed in the
Hardware Torque table at the end of this section.
10: Reconnect the main positive and negative cables
at the batteries.
11: Remove the blocks from behind the wheels.
12: Release the parking brake and test drive.
This section is one section of a complete service
manual. Before starting any procedure, read all
warnings and instructions that are located in the
Service Guidelines chapter.
WARNING
Do not reuse the original pinch bolt and nut. Failure
to replace the pinch bolt and nut may result in
failure of the steering causing loss of control of the
vehicle. This could lead to severe bodily injury and/
or property damage.
Make sure that the pinch bolt is not aligned with the
flat on the steering shaft. Aligning the bolt with the
flat could result in failure of the steering and loss of
control of the vehicle. This could lead to severe bodily
injury and/or property damage.
WARNING