Taylor-Dunn B0-210-36, Service And Replacement Parts Manual

Page: 87 / 188

Brakes
Page 87
MB-210-13
B-200 & B-210 Models
Parking Brake, Hydraulic Brakes
Note: Hydraulic brakes are optional. The service
brake must be properly adjusted before
attempting to adjust the parking brake.
Refer to
Adjust the Service Brakes
for
information regarding adjusting the service
brakes.
1: Release the park brake.
2: Loosen the clevis jam nuts on the connecting rod.
3: Loosen the connecting rod.
4: Adjust the park brake linkage so that the angle
between the connecting rod and the cross shaft
tab is at 60 degrees.
5: Tighten the connecting rod so that all slack is
removed from the brake cables, but not so much
as to actuate the brakes.
6: Tighten the jam nuts on the connecting rod and
park brake linkage.
7: Set the park brake.
8: Reconnect the main positive and negative cables
at the batteries.
9: Remove blocks from behind the wheels.
10: Release the park brake and test drive the vehicle.
Brake linkage with protractor in place
at 60 degrees