Taylor-Dunn B 50, Operation, T Roubleshooting And Replacement Parts Manual

Page: 223 / 233

APPENDIX A PAGE 2
Special Tools
Special Tools
D E S C R I P T I O N P U R P O S E P A R T N U M B E R
Pinion Seal Installation Tool
Used to install the pinion seal on all chain drive trucks
with the band style brake or the speed sensor on the
chain case cover.
43-201-50
Chain Case Centering Tool
Used to center the chain case on the pinion shaft on all
chain drive trucks with the band style brake or the speed
sensor on the chain case cover. Includes instructions.
41-532-50
Test Light
Used for testing electrical circuits. Powered by the truck
batteries, switchable for 12, 24, 36, and 48 volts.
62-027-00
Accelerator Test Harness
Used to test the solid state accellerator module part
number series 62-033-XX.
62-027-31
PMC Test Kit
Includes 62-027-00, 62-027-31, and supplementary
troubleshooting manual M3-001-06. For controllers
equipped with pins labeled KSI and #2 only.
62-027-60
Curtis PMC Handheld
Programmer
Used to test and program the 62-215-00 PMC speed
control used on early model C4-25 Huskey.
62-027-10
GE EV1 Analyzer
Used to test the GE EV1 speed control.
62-027-20
Disc Brake Boot Installation
Tool
Used to install the rubber boot on all disc brake bodies.
41-350-13
Pin Removing Tool
Used to remove pins and sockets from AMP connectors.
75-440-55
Pin Removing Tool
U s e d t o r e m o v e p i n s a n d s o c k e t s f r o m M O L E X
connectors.
75-442-55
Hydrometer
Used to check the specific gravity of battery electrolyte.
77-200-00
Battery Filler
Used to safely add water to batteries.
77-201-00
Retaining Plate Depressor
U s e d t o h o l d d o w n t h e r e t a i n i n g p l a t e w h e n
disassembling the steering gear on trucks equipped with
the tilt steering.
96-500-39
Fork Collar Weld Jig
Used when replacing the fork collar on models MX-600
and SS5-36.
96-500-40
Secondary Sheave Holder
Used to hold the secondary sheave (pulley) from turning
on models R6-80 and B6-10 with the Yamaha drive.
96-500-14
Solder Kit For Field Stud
Used to solder the aluminum field wire to the field stud.
For use on motors with soldered connections only.
70-210-63
Pinion Gear Holding Tool
Used to align the Pinion Gear and Case during assembly
and disassembly.
96-500-42