Taurus WALK ON WATER, Manual, Page: 10 / 60

- After each use, wipe all surfaces with a clean,
dry cloth.
MAINTENANCE AND CLEANING
- Clean and wipe the exterior of the appliance
and all accessories removing all remaining
water with a drop cloth.
-Regularly check for obvious defects suhch as
loose fixings and worn or damaged compo -
nents.
- Empty the detergent tank and clean it with
current water, so all the remaining detergent is
wiped out.
STORAGE
- Dismount the unit following the steps on moun -
ting but afterwards.
- Ensure cables are not trapped when stroing.
If any anomaly is detected, check the following table.
No detergent suction Detergent applicator is clogged
Clean applicator with warm water. If
it not works, replace the applicator
Pump does not reach the
necessary pressure
Water inlet filter is clogged Clean water inlet filter
Pump is sucking air from hose
connections
Check that connections and locking
ring are properly tightened
Nozzle is worn or not correct
Bring the appliance to any customer
service
Unloader is clogged or worn
Valves are clogged or worn
Fluctuating pressure
Pump is sucking air from hose
connections
Check that connections and locking
ring are properly tightened
Clogged nozzle
Clean the nozzle with the typ
cleaner.
Valves are dirty, worn or stuck
Bring the appliance to any customer
service
Water seals worn
Motor suddenly stops
Extension cord is too long or
wire size too small
Remove extension cord
Thermal safety switch has
tripped
Check the voltage in the main
supply match the voltage indicated
on the Rating Label