N
E
INSTRUCTIONS FOR USE
BEFORE USE:
Remove the appliance’s protective film.
Make sure that all products’ packaging has
been removed.
Ensure that the selected tension on the voltage
selector coincides with the tension of the
mains.
USE:
Connect the appliance to the mains.
Pull the telescopic tray.
Turn the appliance on, by using one of the
speed selection buttons (Fig.3).
LIGHT FUNCTION:
The appliance includes a light function, which
illuminates the working area under the
appliance (Fig.3).
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
Stop the appliance by pressing the stop button
(Fig.3).
PRACTICAL TIPS:
It is recommended to keep the filters clean,
grease and dirt in the filters decreases the
efficiency of the engine and increases its
energy consumption.
Adjust the extraction speed according to the
amount of smoke, working at high speeds with
little smoke consumes more energy.
CLEANING
Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
Never submerge the appliance in water or any
other liquid or place it under running water.
If the appliance is not maintained in good
cleaning condition, its surface can degrade and
inexorably affect the life of the appliance and
lead to a dangerous situation.
Then dry all parts before its assembly and
storage.
CLEANING THE ALUMINUM FILTERS
The filters can be cleaned by hand or with the
dishwasher. It is advisable to clean them
monthly.
NOTE: Cleaning the filters in the dishwasher
may change colour slightly.
HAND CLEANING:
Remove the filter as shown in the installation
section.
Brush with a soft brush in a solution of warm
water and a small amount of liquid soap.
Do not use liquid soap alone as it can damage
the filter.
After cleaning, let the water drain and dry well.
DISHWASHER CLEANING:
To clean the dishwasher, you must select a
program at 60ºC, place the filter vertically and
in the lower basket.
Some cleaning products may discolour the filter
permanently, although this will not affect its
performance.
CHANGING THE BULB/S LED
You must purchase the specific spare part for
your model.
Steps to follow:
1. Disconnect the hood from the mains.
2. Press the LED to push towards the
inside.
3. Disconnect the connector.
4. Introduce the new LED and push to
place it in its place.
5. Reconnect the connector.
CHANGING THE FILTERS:
For activated carbon filters (if applicable), it is
advisable to replace them at least once a year
or every 48 hours of operation.
In the case of permanent mesh filters, they do
not need to be replaced.
