OPIS EQUALIZERA PARAMETRYCZNEGO
− 4 −
3
4
1.
2.
3.
4.
5.
6.
7.
TRUE VOICE”
POWER on/off switch.
230V/50Hz EC POWER INPUT socket with AC fuse.
[optional − 100V/120V/60Hz].
Balanced LINE OUTPUT [XLR]
with „
speaker cabinet simulation.
LINE OUTPUT PRE/POST EQ switch.
LINE OUTPUT GROUND LIFT switch.
SPEAKERS output [combo SPEAKON and 6,3mm JACK].
min. impedance 8ohm / min. power 200Watt/rms
HORN on/off switch.
P O W E R
TO REDUCE THE RISK OF FIRE
OR ELECTRIC SHOCK, DO NOT
EXPOSE THIS PRODUCTS
TO RAIN OR MOISTURE
WARNING!
TO REDUCE THE RISK OF
ELECTRIC SHOCK, DO NOT
REMOVE COVER.REFER
SERVICING TO QUALIFIED
SERVICE PERSONNEL
CAUTION!
(8ohm)
EXT.
SPEAKER
OFF
ON
HORN
Power output:
300W/4ohm − 200W/8ohm
(8ohm − internal speaker)
LINE
OUT
PRE
POST
GND
LIFT
Speaker
simulation
Made in Poland
series
10-001
1010
NUMBER
Fuse: 2.5A−230V 5.0A−120V
TS
1
2
7
5
4
3
6
PROTECTIONS
REAR PANEL
The amp is armed with several Power Amp protection circuits.The
PROTECTION LED is placed at the front panel of the unit and indicates it’s
activities. If PROTECTION LED is constantly illuminated while the
instrument is connected, then the Power Amp is blocked by PROTECT
circuits. Temporary overload or short circuit at Speaker Output will cause
PA to be blocked for about 4 seconds. In these circumstances, the
cabinet's connection and cabinet's impedance should be checked (4 ohms
is the lowest impedance allowed ). After 4 seconds the amp should start
working again by itself. If the amp does not restart after 4 seconds, it may
be an indication of overheating. It may take a few minutes before the
cooling system will decrease the temperature of the PA to a normal,
operational level.
