AFTER SALES SUPPORT
1300 922 271
MODEL NUMBER: BT-CD 18/1 Li ,
10/11
9
6.5 On/Off switch (Fig. 6)
Infinitely variable speed control is possible with the
On/Off switch (3). The further you press the switch, the
higher the speed.
6.6 Battery capacity indicator (Fig. 5)
Press the switch for the battery capacity indicator (11).
The battery capacity indicator (10) indicates the charge
state of the battery on 3 colored LEDs.
All LEDs illuminate:
The battery is fully charged.
The yellow and red LED illuminate:
The battery has an adequate remaining charge.
Red LED illuminates:
The battery is empty, recharge the battery.
6.7 Changing the accessory (Fig. 7)
Important!
Set the forward / reverse switch (Fig. 6/Item
2) to its centre position whenever you carry out any work
(for example changing the accessory, maintenance work,
etc.) on the tool.
•
The tool is fitted with a chuck (7) with an automatic
spindle stop.
•
Open the chuck (7) by rotating it counter-
clockwise. The chuck opening (a) must be large
enough to hold the tool (drill bit or screwdriver bit).
•
Select the suitable accessory. Place the accessory
into the chuck opening (a).
•
Tighten the chuck (7) by rotating it clockwise and
then check that the tool is secure.
6.8 Screwdriving
We recommend using self-centering screws (e.g. Torx
screws, recessed head screws) designed for reliable
working. Be sure to use a bit that matches the screw in
shape and size. Set the torque as per Section 6.2 of the
user guide.
6.9 Selecting 1st gear or 2nd gear (Fig. 5)
By adjusting the selector switch (6), you can work with a
faster or slower turning speed. Change the gear only
when the drill is at a standstill. If you fail to observe this
point, the gearing may be damaged.
6.10 LED lamp (Fig. 2)
The LED lamp (12) can be used in poor lighting
conditions to illuminate the area where you want to
drill or screw. The LED lamp (12) will be lit automatically
as soon as you press the ON/OFF switch (Fig. 1/Item 3).
7. Cleaning, maintenance and
ordering of spare parts
Always pull out the mains power plug before starting
any cleaning work.
7.1 Cleaning
Keep all safety devices, air vents and the motor housing
free of dirt and dust as far as possible. Wipe the tool
with a clean cloth or blow it with compressed air at low
pressure.
We recommend that you clean the tool immediately
each time you have finished using it. Clean the tool
regularly with a moist cloth and some soft soap. Do not
use cleaning agents or solvents; these could attack the
plastic parts of the tool. Ensure that no water can seep
into the tool.
7.2 Maintenance
There are no parts inside the equipment which
require additional maintenance.
7.3 Ordering Spare Parts
Contact our After Sales Support on 1300 922 271 and
quote the following data when ordering replacement
parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
8. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste.