Taurus ROW-X, Assembly And Operating Instructions Manual

Page: 13 / 44

101
80
80
90
30R
30L
90
90
2
2
2
2
29
1
47
80
A 1 A 2 A 3 A 4
ROW X
13
2.3 Assembly
Before assembly, take a close look at the individual assembly steps shown and carry out the assembly
in the order given.
L
NOTICE
First loosely screw all parts together and check that they fit properly. Then tighten the screws
using the tool only when you are instructed to do so.
Step 1: Assembly of rear base and monorail
1. Mount the rear base (1) on the mono rail (2) with M6 X 16L hexagon screws (80) and two M6
Nylon nuts (101) (see fig. A1). Tighten the screws.
2. Slide the seat pad (29) on the mono rail (2) (see fig. A2).
3. Mount the left (30L) and right rear cover (30R) with four M4 X 12L screws (90) (see fig. A3).
4. Mount the bumper (47) on the mono rail (2) with two M6 X 16L hexagon screws (80). Please pay
attention to that the left (30L) & right rear cover (30R) are correctly positioned (see fig. A4). Then
tighten all screws.
Down
Up