Taurus I603MT, Installation Manual

Page: 29 / 96

Spill overs on the
touch controls
1. Switch off the power supply.
2. Soak up the spill
3. Wipe the touch control area
with a clean damp sponge
or cloth.
4. Wipe the area completely
dry with a paper towel.
5. Switch on the power supply
to the hob.
• The hob may beep and turn
itself off, and the touch controls may not
function while there is liquid on them.
Make sure you wipe the touch control
area dry before turning the hob back on.
Maintenance of the Hob
If you find something goes wrong for your hob, before contact the service or where you
purchased it, please check whether below:
1. There is no power to the appliance:
- Check whether there is a power cut of your department;
- Check whether the appliance be connected to electricity properly;
- Has the timer setting elapsed;
- Whether it reaches the longest cooking time setting and auto shut off;
- Whether there is liquid boiling over touch control panel and overflow protection devices auto shut off;
2. The touch control panel buttons can’t be active:
- Whether it’s under “Child Lock”, which there is “Lo” shows in timer displayer;
- Whether liquid/wet cloth over touch control panel active overflow protection;
3. After cooking there is “H” shows on display:
- This is normal. The hob is with Residual Heat Warning safety features. It will remain on until the
surface is cool enough for touch.
4. After turn off, the fan of induction hob remains working for a while:
-This is normal, this is to help appliances completely cool down.
5. Some pans make crackling or clicking noises during use of induction hob:
-This is normal, it’s the sound of induction coils during working, and for different construction of your
cookware, the clicking might be slightly different.
6. The glass is being scratched:
-Check whether you use unsuitable cookware, like rough-edged cookware.
-Check whether unsuitable, abrasive scourer or cleaning products being used.
Failure Inspection for induction hob
If an abnormality comes up, the induction hob will enter the protective state automatically and display
corresponding protective codes:
Problem Possible causes What to do
E1/E2
Abnormal supply voltage Please check whether power