Taurus DESIGN LINE DUAL PULLEY, Assembly Instructions Manual

Page: 14 / 36

14
Dual Pulley
Step 3
1. Attach the two Swivel Pulley Housings (13) to the Right and Left Cable Height Adjuster (11 & 12)
using two bolts (39), four washers (51) and two nylon nuts (56).
2. Mount the two Upright Frames (5) to the Base Frame (1) and the Top Frame (2) using four bolts
(41), eight washers (52) and four nylon nuts (57).
3. Insert the Guide Rods (6) into the slots of the Base Frame (1).
4. Slide the Rubber Donuts (23) onto the Guide Rods (6), see Fig. 1 and Fig. 2.
࣑
ATTENTION
Check the number of weight plates (18) of the weight block. If you have a total of 14 Weight
Plates (18), use the Stack Spacers (19), when assembling, see fig. 1. If you have 19 Weigh Plates
(18), the Stack Spacers (19) are not needed, see fig. 2.
5. Slide all Weight Plates (18) of the weight block one by one onto the Guide Rods (6).
6. Mount the Top Plate (16) to the Selector Rod (17) using the bolt (43) and tighten the bolt.
7. Screw the Pulley Block (15) into the slot of the Top Plate (16).
8. Insert the Selector Rod (17) into the weight block.
9. Insert the Guide Rods (6) into the holders of the Guide Rod Retainer (9).
10. Fix the Guide Rods (6) to the Guide Rod Retainer (9) using two screws (50).
11. Mount the Guide Rod Retainer (9) to the Top Frame (2) using two screws (45).
12. Tighten the screws and bolts.