Taurus CROSSBACK GLOW, Instructions For Use Manual, Page: 8 / 52

HOW TO CHECK THE BATTERY’S CHARGE
LEVEL:
Press the ON/OFF button (G), the pilot lights
that indicate if it is charged will light up.
If all four pilot lights come on this means that
the appliance is fully charged.
If no pilot light lights up, this means that the
battery is completely flat.
NB: For a long battery life, it is advisable to
charge the battery, only, when it has run out
completely.
INSTRUCTIONS FOR USE
BEFORE USE
Make sure that product’s packaging has been
removed.
Before using this product for the first time, it is
important to make a full charge of batteries.
Prepare the appliance according to the function
you wish to use:
USE
Turn the appliance on, by using the on/off
button.
Select the desired speed with the speed
selector. (N) This function is very useful, as
it makes it possible to adapt the speed of the
appliance to the type of work that needs to be
done.
FITTING AN ACCESSORY TO THE HAND
VACUUM
The hand vacuum is designed in such a way
that it allows the following accessories to be
fitted: (use the combination that best meets
your requirements). (Fig.1).
Furniture brush: Equipped with a brush at the
end, which brushes the surface as it is used.
Crevice nozzle: Specially designed for getting
into cracks and difficult corners.
We can insert the accessories into the tube.
(*) Press the button to bend the flexible tube
and access hard-to-reach areas. (Fig.2)
ONCE YOU HAVE FINISHED USING THE
APPLIANCE
Turn the appliance off using the on/off button.
Clean the appliance.
CLEANING
Disconnect the battery charger from the mains
and allow it to cool before undertaking any
cleaning task.
Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
Do not use solvents, or products with an
acid or base pH such as bleach, or abrasive
products, for cleaning the appliance.
Never submerge the appliance in water or any
other liquid or place it under running water.
EMPTYING THE DUST BOX
Empty the dust box when it is full (observation
facilitated by transparent windows), or when
vacuuming power is notably reduced.
Open the lid of the dust box pressing the
button to open the lower tank cover (M) located
on the inside of the handle and empty the
contents into the appropriate waste disposal
receptacle. (Fig.3)
Check the condition of the dust box filter.
CHANGING THE FILTERS
Dust tank EPA filter (high efficiency air filter
that efficiently retains spores, ash, sawdust,
pollen…), it is advisable to change it a least
once a year or after every 50 hours of use, or if
its potency diminishes remarkably.
TO REMOVE THE FILTERS
Remove the dust tank by pressing the button
(N) turning to the left, as indicated by the arrow
and the padlocks. (Fig. 4)
Extract the cyclone by turning to the left,
the filter is inside the cyclone and to remove
the filter from its anchor, turn to the right, as
indicated by the arrow and the padlocks.
(Fig. 5)
To reassemble the filter, proceed with the
above instructions, in reverse order.
CLEANING THE ROTARY BRUSH
To remove the brush:
At the bottom of the shoe, you have to move
the tab towards the open padlock and unhook
the side piece that fixes the brush and pulls it
out. (Fig. 6)
Remove the brush and clean.
To reassemble, follow the above instructions
but in reverse.
SUPPLIES
Supplies can be acquired from distributors
and authorised establishments (such as filters,
battery etc...) for your appliance model.
Always use original supplies, designed
specifically for your appliance model.