Taurus AP2040, Manual

Page: 8 / 52

-Hold the “Switch button” for 3 seconds again,
the child lock indicator light would be off with
this function.
FILTER BUTTON:
-When the filter life expires (about 2500hr), the
filter replacement indicator will flash to remind
you, it is high time to change the filter.
-Please replace the filter consulting figures
1,2,3,4.
-After changing the filter, hold the “Filter button”
down for 5 seconds to reset
SLEEP BUTTON:
-In the state of power-on,press the “Sleep but-
ton” briefly, the purifier enters the sleep mode,
and all the lights except the sleep status indica-
tor are off. If any key is pressed, the display will
resume for 30 seconds, and then press any key
again within 30 seconds to exit sleep and enter
the automatic mode. After 30 seconds without
button operation, the display will be off.
AIR QUALITY DISPLAY
-Excellent: Blue
-Good: Green
-Mild: Yellow
-Bad: Red
ONCE YOU HAVE FINISHED USING THE
APPLIANCE:
-Turn the appliance off, using the on/off button.
-Unplug the appliance from the mains.
CLEANING
-Disconnect the appliance from the mains and
allow it to cool before undertaking any cleaning
task.
-Clean the electrical equipment and the mains
connection with a damp cloth and dry. DO
NOT IMMERSE IN WATER OR ANY OTHER
LIQUID.
-Clean the equipment with a damp cloth with a
few drops of washing-up liquid and then dry.
-Do not use solvents, or products with an acid or
base pH such as bleach, or abrasive products,
for cleaning the appliance.
-Do not let water or any other liquid get into the
air vents to avoid damage to the inner parts of
the appliance.
-Never submerge the appliance in water or any
other liquid or place it under running water.
-The plug must be easily accessible so it can be
disconnected in an emergency.
INSTRUCTIONS FOR USE
BEFORE USE:
-Make sure that all the product’s packaging has
been removed.
-Remove the appliance’s protective film and
follow figures 1,2,3,4.
-To eliminate the smell given off by the appli-
ance when used for the first time, it is recom-
mended to have it on at full power for 2 hours in
a well-ventilated room.
-Prepare the appliance according to the function
you wish to use:
USE:
-Extend the cable completely before plugging
it in.
-Attach the appliance to its base / connector
making sure that it is correctly fitted into place.
-Attach the appliance to its base making sure
that it is correctly fitted into place.
-Ensure that the electronic connector is properly
attached to the appliance.
-Connect the appliance to the mains.
-Guide the appliance to direct the flow of air in
the desired direction.
-Turn the appliance on, by using the on/off
button.
-Press the “ON button” , the machine will enter
the auto mode (all fan speed LED lights on);
in the auto mode, the machine determines the
running wind speed according to the air quality
-Press two times to enter the first fan speed,
and the first indicator is on;
-Press three times to enter the second speed,
and the second indicator is on;
-Press four times to enter the third speed opera-
tion, and the third indicator is turned on;
-Press five times to enter the fourth speed and
light the fourth indicator;
-Press six times to turn off;
CHILD LOCK:
-Long press the “Switch button” for 3 seconds to
enter the child lock mode,
-the child lock indicator light will show blue. In
the child lock mode, other button will be locked.