Taurus 918693000, Manual

Page: 7 / 40

AUTO SHUT OFF
-When the iron is stationary for more than 7
minutes, the iron goes out of power mode
-The poweroff sign flashed on the display,
accompanied by six buzzing sounds
-Press the steam switch to restore the power
-Irons will not be cut off during steam discharge
-If you need stop the process switch off the item
ANTI DRIP
-This iron is equipped with a drip stop function:
the iron automatically stops steaming when the
temperature is too low to prevent water from
dripping out of the soleplate.
ANHYDROUS DETECTION (NO WATER
DETECTION)
-In the course of working, if there is no water in
the water tank, the pump will automatically stop
working to protect the life of the pump
DEFECTS AND REPAIRS
-Do not attempt to replace a defective mains
lead .The appliance has to be returned to an
authorized service centre for repair.
CORD STORAGE
-Follow Fig. 6
FAULTSREASONS AND SOLUTIONS
IRON EMITS AN ODOR OR SMOKE
-Iron gives off an odor when turned on for the
first time. Oils used during manufacture need
to be burnt off allow ten minutes for odor to
disappear.
IRON DOES NOT HEAT
-The iron should be plugged into a 230 Volt ,
Whether the power switch is turned on
IRON DOES NOT STEAM
-The water tank many be empty. Turn off the
steam regulator and add water. Allow the iron
to heat, and then set the turn on to the steam
setting.
IRON IS LEAKING
-The temperature setting is too low to produce
steam. Shot of steam used too much, allow iron
to re-heat.