3
4
Connect the base to the assembled rear panel and
headboards
Connect The Front Panel
5
Tighten All Bolts
Maintaining Your Tasman Cot
Two months after assembling the cot, re-tighten all connector bolts as some may loosen as the cot settles.
panel connector bolts and 4 x
metal cross dowels. Repeat the
steps in section 3 to connect the
front panel.
4
Connect the base to the assembled headboards and rear panel, using 4 x base connector bolts and 4 x metal
cross dowels. (Fit the base in the upper bassinet postion for babies under six months and who cannot sit up,
fi
t the
the base in the lower cot postion for babies over 6 months or who can sit up)
Fit the back of the base
fi
rst allowing the front of the base to rest on the ground
Insert the metal cross dowel into the back left base hole and insert the connector bolt through the headboard and
into the cross dowel and tighten but leaving a 5 mm gap, repeat for the back right corner.
Lift the front of the base up and into position and repeat above steps
Note: See detail picture below the metal cross dowel must align for the connector bolt to insert into the thread, it
can be adjusted using a screwdriver.
4 x base bolts
4 x rear panel bolts
4 x front panel bolts
