TRAMPOLINE ENCLOSURE ASSEMBLY
22
Trampoline Enclosure Assembly
BEFORE YOU BEGIN:
This trampoline should only be used when the enclosure netting is properly assembled. The trampoline
netting must be checked thoroughly before each use to ensure there are no tears or damages. Please
carefully read all the Important Safety Instructions contained in this manual and all warnings on the product
before use.
Review all steps before assembly and read all precautions before using the trampoline. At least two adults
are required to assemble this trampoline enclosure. Protective gloves should be used during assembly to
avoid injuries during installation by the hooks and goggles should be worn to avoid injuries to the eyes.
Step 12
– Assemble the Enclosure Poles
Attach End Cap (# O) to the Lower Frame Tube with Foam (# B)
– the side with the larger
opening.
Place Gap Spacer (# E) in between Lower Frame Tube with Foam (# B) and Vertical Leg Extension with 2
holes (# 6B) and secure them together using Bolt (# F), Arc Washer (# J), Large Spring Lock Washer (#G)
and Cap Nut (# H) in the order shown below. Repeat this step for all the frame tubes.
IMPORTANT:
The smaller arc of the Gap Spacer (# E) must face the Lower Frame Tube with Foam (# B).
The small hole located at the top of #B must face outward for connection to the enclosure frame in a later
step.
There may be some deformation of the foam on the enclosure tubes due to compression during transport.
This is normal and the shape of the foam should recover naturally over time.
DO NOT PLACE HANDS
BETWEEN THE POLES
DURING ASSEMBLY. MAKE
SURE TO WEAR PROTECTIVE
GLOVES TO AVOID INJURIES
DURING ASSEMBLY.
