Taski swingo 855B power, Instructions Of Use

Page: 93 / 212

91
Removing and cleaning the squeegee
Empty and clean the recovery tank and fresh water tank
Proceed as follows:
Cleaning the recovery tank and fresh water tank
• Lift the squeegee.
Allow the suction unit to run on so
that the remaining waste water in the
hose is sucked up.
• Press the Suction unit ON/OFF but
-
ton.
The display lights up; the suction en
-
gine stops.
• Switch off the machine.
Attention:
The machine must now be emptied and
cleaned. Switch off the machine (main
switch) and remove the plug from the
mains socket.
• Pull the suction hose from the connector.
• Lift the squeegee with your foot.
• Compress the lock springs. The
squeegee is released and can be re
-
moved from the squeegee holder.
• Clean the squeegee under running water using a brush.
Notice:
Only cleaned and intact blades ensure op
-
timal suction results!
Notice:
Drain water or cleaning solution must be
disposed of in compliance with the nation
-
al regulations.
Notice:
When draining the recovery tank, the reg
-
ulations of the detergent supplier regard
-
ing personal protective equipment of the
cleaning solution manufacturer must be
observed.
• Take the drain hose out of the holder.
• Open the red or blue cover at the level of the handle, lower
the end of the hose slowly and empty the recovery or fresh
water tank.
• Open the tank cover until the support
engages in the tank wall.
• Rinse the recovery tank and the fresh water tank thorough
-
ly with clean water.
• Remove the dirt sieve (yellow), emp
-
ty it and thoroughly rinse it under run
-
ning water.
• Take out the suction filter (yellow)
and remove the dirt with a cloth or a
soft brush.
• Check the float to make sure it is fully
functional and repair any fault
• After you have finished emptying the tanks, screw the red
and blue cover back on and hang the hose on the holder.
Attention:
Clogged suction filters may impair the suc
-
tion performance.
• Reassemble the dirt sieve (yellow) and the suction filter.
• Put the drain hoses back into the holder.
EN