©Copyright Task Force Tips, Inc. 2007 - 2016
LIY-410 July 10, 2016 Rev05
TASK FORCE TIPS, INC.
MADE IN USA • www.tft.com
3701 Innovation Way, Valparaiso, IN 46383-9327 USA
800-348-2686 • 219-462-6161 • Fax 219-464-7155
TEACHING ID CODE:
NOTE: When the operator station is purchased at the same time as RC monitor, handheld unit will be pre-taught at factory.
NOTE: If the monitor is mounted to an RC Extend-A-Gun, make sure the Extend-A-Gun is in the raised position.
NOTE: Before teaching, monitor should be powered down.
NOTE: If multiple monitors are present, apply power only to the monitor being taught, otherwise possible confl icts may occur.
Every monitor has a unique ID code that must be “taught or transferred” to the wireless handheld unit. This unique ID code allows
multiple monitors to be used in one location without interference. Perform the following procedure to teach the handheld unit.
On Wireless Handheld Unit Without Display:
-Press POWER button to turn on electronics.
-Press and hold both LEFT & RIGHT buttons simultaneously for 5 seconds.
-Continue to press the LEFT & RIGHT buttons and then press UP button for 2 seconds.
-Release buttons. After several seconds the OSC & STOW lights will fl ash rapidly to indicate that the unit is in teach mode.
On Wireless Handheld Unit (with Display):
- Enter confi guration mode by pressing center MENU button for 5 seconds
- Press & release MENU button until RFID LEARN is displayed above left button
- Press & release RFID LEARN button, Radio will confi gure and wait for ID code
On Monitor Control Box:
-Apply power to monitor.
-Press and hold both LEFT & RIGHT buttons simultaneously for 5 seconds.
-Continue to press the LEFT & RIGHT buttons and then press UP button for 2 seconds.
-Release buttons. After several seconds the OSC & STOW lights will fl ash rapidly to indicate that the unit is in teach mode.
ID code is automatically transferred to the wireless handheld unit.
-OSC & STOW lights on handheld unit will stop fl ashing after ID code is transferred.
-Press DOWN button on monitor control box to exit teach mode.
-Cycle power off and back on to monitor.
In the event the handheld unit does not link up with the monitor, perform the following at the monitor operator station and the
handheld unit.
- Turn off power.
- Press and hold DOWN button.
- Apply power to the monitor, continue to hold DOWN button for 3 seconds.
- Release DOWN button.
- After green POWER light stops blinking, test wireless handheld unit.
- Repeat above procedure for “Teaching ID Code”
CHANGING BATTERIES IN WIRELESS HANDHELD UNIT:
Four (AA) Batteries, Lithium Recommended
-Remove two (2) screws on backside of handheld unit and slide bottom half of rubber bumper off enclosure.
-Replace batteries verifying that polarity is correct.
-Replace rubber bumper and retaining screws.
NOTICE
Properly dispose of old batteries. Do not puncture, incinerate, or disassemble batteries. Do
not mix battery types.
