©Copyright Task Force Tips, Inc. 2008-2014
LIX-300 April 29, 2014 Rev18
22
7.0 MAINTENANCE AND INSPECTION
The Hurricane monitor requires little maintenance. The monitor should be kept clean and free of dirt. All controls should be checked
for freedom of movement and proper operation before each use. Any inoperable or damaged parts should be repaired or replaced
immediately.
• For Hurricane Fixed Monitor make sure that the monitor swivels freely on its base when the anti-rotation lock is released and that
the monitor will not rotate when the anti-rotation lock is engaged.
• Make sure that the monitor’s axis’ rotate freely and without binding throughout its range of travel.
• Make sure that there are no leaks when the monitor is fl owing water.
• Make sure the nozzle is free of debris.
Equipment can be returned to the factory for service and/or testing.
7.1 LUBRICATION
7.1.1 ELEVATION CONTROL WORM GEAR
In the event that the operation becomes stiff, grease may be applied to the elevation worm gear grease port shown in Fig. 3.2. Turn
the hand wheel to raise the nozzle to its highest position and pump medium viscosity automotive chassis grease into the grease
fi tting on the Elevation worm gear housing until excess appears at the joint. See Fig. 3.2 for grease zerk location.
7.1.2 HORIZONTAL ROTATION WORM GEAR
The Hurricane RC and Hurricane monitor generally should not require greasing in the Horizontal (left-right) worm gear. In the event
that the operation becomes stiff, grease may be applied to the horizontal worm gear grease port shown in Fig. 3.2A and Fig. 3.2B.
Use medium viscosity automotive chassis grease. Apply only enough grease to restore normal operation. If greasing does not restore
normal operation, inspect for other causes of stiff operation.
Note: Do not over pump grease to Horizontal worm gear. The monitor’s Horizontal worm gear greased areas lead to the
wire skirt/cable guide that would trap several pounds of grease before becoming visible.
8.0 TROUBLESHOOTING
SYMPTOM
POSSIBLE CAUSE
REMEDY
Leaks
Debris or damage in seal area
Clean out debris or replace damaged parts
Elevation Binding
Debris or damage to elevation drive parts
Clean out debris or replace damaged parts
Lack of lubricant
Grease, see section 7.1
Horizontal Rotation
Binding
Debris or damage to horizontal drive parts Clean out debris or replace damaged parts
Lack of lubricant
Grease, see section 7.1
