7 – Module operations—Digital trim and delay (global)
TASCAM DM-24 Reference Manual
59
Channel delay is only possible on modules 1 through
24. See also “Global digital delay” on page 59.
Digital delay units (UNIT)
Choose either sam-
ples (
SAMPLE
) or milliseconds (
ms
) as the unit in
which channel digital delay is measured.
See also “Global digital delay” on page 59.
Digital trim and delay (global)
Two dedicated screens allow the viewing and setting
of the digital trim and delay parameters.
Global digital trim
1
With the
SHIFT
indicator lit, press the
DIGI.
TRIM/DELAY
key until the following screen
appears:
Use the cursor keys and the
SEL
keys to navigate the
cursor round the screen.
Use the PODs to set the amount of digital trim from
-
50.0dB
to
+10.0dB
in 0.5dB steps.
Linked channels share the same digital trim setting.
Fader control
At the top of the screen is a button
which allows the faders to be used for setting the trim
levels (as described in “Using the faders to change
values” on page 14).
Setup
A master trim can be applied to selected
channels by moving the cursor to the bottom left
position setting the desired value with POD 1 and
pressing
ENTER
.
The scope of the setting is determined using POD 2:
either
ALL
,
EVEN
(even-numbered channels),
ODD
(odd-numbered channels),
1-8
,
9-16
,
17-24
or
25-32
.
When
ENTER
is pressed, a popup message appears
(
Ch parameters setup?
). Press
ENTER
again to con-
firm, or a cursor key to cancel.
Global digital delay
1
With the
SHIFT
indicator lit, press the
DIGI.
TRIM/DELAY
key until the following screen
appears:
Use the cursor keys and the
SEL
keys to navigate the
cursor round the screen.
Use the PODs to set the amount of digital delay up to
16,383 samples (the maximum in high sampling fre-
quency is 32,767 samples). This is equivalent to
341.2 milliseconds at 48k or 96k sampling frequen-
cies, or 371.5 milliseconds at 44.1k or 88.2k sam-
pling frequencies.
This delay can be used to compensate for signal pro-
cessing, etc. and can be applied either before or after
the fader. It is available for channels 1 through 24
only.
NOTE
This is not a delay or echo effect as provided by the
internal effectors.
Linked channels share the same digital delay setting.