Friction Wheel Replacement
If the snow blower fails to drive with the drive
clutch engaged, and performing the clutch control
cable adjustment fails to correct the problem, the
friction wheel may need to be replaced.
1. To prevent spillage, remove all fuel from tank by
running engine until it stops. Remove the key to
avoid unintended starting and allow unit to cool
completely.
2. Carefully pivot the snow blower up and forward
so that it rests on the auger housing.
3. Remove the frame cover(s) from the underside
of the snow blower by removing the screws
which secure the cover(s).
4. On wheeled model, remove the right-hand
wheel by removing the axle lock pin.
Carefully remove the hex nut which secures the
hex shaft to the snow blower frame and lightly tap
the shaft’s end to dislodge the ball bearing from
the right side of the frame. Be careful not to
damage the threads on the shaft.
Remove the other bearing from the left side of the
frame by removing the snap ring.
Carefully position the hex shaft downward and to
the left before carefully sliding the friction wheel
assembly off the shaft.
