Page 14 of 23
Rev B Mar 2012
Ensure that the inner flue sits central in the outer, move the fire slightly to adjust. Fire can be
bolted in position once lined up properly, if fire is not straight add washers under plate
around bolt holes to correct.
Important!
Your fire is heavy (45kg) and precautions must be taken to ensure it is
securely anchored to your floor to reduce the risk of it tearing free in an
accident.
We
strongly recommend
that bolts are run right through the floor with a large plate or steel
straps placed on the underside to stop bolts from pulling through the floor
.
Important!
Your fire must be closed down completely when you are traveling otherwise it may overheat
as air is forced through it and/or blow back ash or soot into your mobile home.
INSTALLATION OF COWL AND FLUE
The 400 mm long 150 mm diameter stainless steel sleeve supplied with this kit can be
shortened to suit your application, but for motor homes it should be close to the right length
the stainless ceiling finishing panel can be omitted if preferred.
Once the 150mm diameter sleeve has been secured, slide the cowl over this until it bottoms
on the sleeve,
then pull it back approx 20mm and mark mount positions
. (This provides
the air gap for insulating air)
Measure from inside cone to the fire and add 20mm to obtain the flue length
The ceiling panel is used to tidy the fit around the sleeve, on curved ceilings this will have to
be formed to match the curve and the hole will need to be elongated to match the change in
profile.
The flue must be sealed using Maniseal (available from hardware or automotive parts
outlet) or similar product.
Summary of Contents for Little Cracker
Page 13: ...Page 13 of 23 Rev B Mar 2012 ...