Targus Wireless Numeric Keypad
4
Targus Wireless Numeric Keypad
5
This keypad is a plug and play device. It should automatically operate
when the USB receiver is connected to the computer.
Connecting to Your Computer
1. Remove the USB receiver from the back of the keypad.
2. Plug the USB receiver into an available USB port on your computer.
3. Power on the keypad by using the On/Off switch located on the back of
the keypad.
NOTE: WHEN THERE IS COMMUNICATION BETWEEN THE KEYPAD AND THE RECEIVER, THE
LED ON THE RECEIVER WILL FLASH.
• To extend the life of your battery, turn off the keypad while travelling or
when you’re not using it.
Power Management
If the response time of the keypad is slow or it intermittently stops working:
Re-Establishing a New Connection
1. Unplug the USB receiver from the computer.
2. Plug the USB receiver into another available USB port and the LED
indicator will flash for 1 minute to indicate pairing mode is activated.
3. Power on the keypad and press the reset button to re-establish a new
connection.
Battery Life Indicator
The light will turn on when the power is low and batteries need to be
replaced.
