step 7: attach back panel
Begin by installing all of the screws along one
edge of the back panel. Next, using a square
or tape measure, make sure that the cabinet is
square. (If using a tape measure, the distance
from one corner, diagonally to the other corner
should be the same in both directions.) If not,
apply gentle pressure to the diagonally opposite
corners to shift case into alignment. Re-measure
to ensure equal distances. Install the remaining
screws, starting with the corners.
(H4)
x 23
short pan head
screw
7.1. Make sure the short pan head screws go through the pre-drilled holes properly to attach back panel. Do not over tighten screws.
14
hole for anti-tip
