SYSTEM PROGRAMMING -
Menu 1
PAGE 8
INSTALL MANUAL
TRANSMITTER PROGRAMMING
SYSTEM PROGRAMMING -
Menu 1
PAGE 9
INSTALL MANUAL
PROGRAMMING
RS.1
RS.1
PROGRAMMING ADDITIONAL TRANSMITTERS
Turn ignition key OFF to exit remote program mode when all
required remote’s have been programmed.
1 Honk confirms program mode was entered followed by
5 Honks confirming transmitter program mode.
Press and HOLD the valet switch (The Park Light will turn on)
If connected the Horn will Honk once
Continue Holding until the lights turn off and the honk honks 5 times
Cycle the Ignition Key - ON/OFF ON/OFF ON
(Leaving the key ON)
ENTERING REMOTE PROGRAM MODE
The system can lean up to 4 different remote’s. Each remote to be used MUST be
programmed together during the same sequence. For security, when a new remote
is programmed all previous remote’s are deleted.
Press Antenna
Press Unlock
MENU 1
MENU 2
MENU 3
MENU 4
1 - Cycle the Ignition Key On/Off On/Off On (Leaving the key ON)
2 - Press and release the Program Switch 1 time. The park lights will turn on and the horn
will honk to confirm entering program mode.
3 - Select the Program Menu by pressing...
ENTERING PROGRAM MODE
1 -
Cycle the Ignition Key On/Off On/Off On (
Leaving the key ON
)
2 -
Press and
RELEASE
the Program Switch 1 time and the park light will turn on.
(Horn will honk to confirm program mode has been entered)
3 -
Press and
HOLD
the Program Switch for 5 seconds or until the Park Lights flash 3 times.
4 - Turn the ignition key
OFF
to exit.
(
Confirmed by 3 Park Lights flashes/ Horn Honks)
SYSTEM RESET
The system will confirm the program menu by flashing the park lights and with horn honks.
4 - Press and Release the Program Switch to advance through the settings.
(
Confirmed by Park Lights/ Horn Honks & LED flashes)
5 - Press and Hold the Program Switch to change the setting
.
(
Confirmed by Park Lights/ Horn Honks & LED flashes)
6 -
To exit Program Mode, turn the key off.
(Confirmed by Long Horn Honk)
Example- Programming Menu 1, Setting 3 to Double Lock Pulse.
1 -
Cycle the Ignition Key On/Off On/Off On
2 -
Press and release the Program Switch 1 time. (1 Honk/ Park Lights ON)
3-
Press and release the Antenna button to advance in Menu 1. (1 Honk/ 1 flash)
4-
Press and release the program button until the LEDs on the antenna flash 3 times.
**The park lights will flash and the Horn will Honk 3 times to confirm the current setting)
5-
Press and hold the program button. The Park Light will flash once (option 1), pause then flash
twice to confirm option 2 has been selected. The Horn will also Honk 1 time (option 1) then 2
times to confirm the option 2.
6-
Release the program switch and turn off key to exit.
Press and release the Lock/ Unlock button on each of the
transmitter’s to be programmed. The park lights will flash once for
each added transmitter code.
The horn will also confirm each new transmitter by honking once.
Release the valet switch once all transmitter’s are entered.
*Maximum 4 remote’s
Press Start
Unlock & Start
