taranis Q X7, Manual, Page: 10 / 13

extended at +90% servo motion. The servo will ‘stall’ if commanded outside this range, and
stalling is hard on a servo. We can limit the range that
CH3 can command to prevent servo stall.
Page down thru the Model Setup menu to the OUTPUTS screen. With default settings your
outputs screen should look like this:
Your OUTPUTS screen now looks like this:
Full upward throw on the Throttle stick axis will now provide only 90% of full upward servo
motion, and full downward throw will provide only 75% of downward servo motion. No servo
stall!
The OUTPUTS screen allows direct limiting of the motion range commanded on
each side of the motion center point. Here we will limit servo motion to 75% of
normal below the center point and 90% above.

Use the scroll wheel to highlight the CH3 line, then tap the ENTER button to
bring up an action menu.

Tap ENTER to enter the EDIT screen.

Scroll down to the Min line, tap ENTER, scroll to -75.0 and tap ENTER .

Scroll down to the Max line, tap ENTER, scroll to 90.0 and tap ENTER .

Tap EXIT twice.