Page | 12
rev 3.0.06
6
Before you fly
6.1
Battery and fail safe
Before flying:
Set the battery alarm threshold to suit your battery chemistry, for both the tx and rx.
Set the failsafe
6.2
Field guide printout
Print a copy for field use:
Flight modes
Adjustment
Adjuster control
Notes
Launch
Launch camber
S2 (9XD), or F2 (X9E)
Pr/- 50% fine tuning of Launch preset
Zoom
Zoom camber
S1 (9XD), or F1 (X9E)
Adjusts reflex 0 – 100%
T1-thermal
Thermal camber
LS
Pr/- 50% fine tuning of T1-thermal preset
T3-speed
Snapflap volume
Throttle trim
Trim forward=zero snap, trim back = max snapflap
Landing
Spoiler comp
Throttle trim
Trim back=zero comp, trim forward =max comp
[all]
Aileron Diff
Rudder trim
Diff saved individually for each flight mode.
Range is 0 - 80%
[all]
Aileron trim
Aileron trim
Shared by all flight modes
[all]
Elevator trim
Elevator trim
Saved individually per flight mode
7
Simple modifications
7.1
Launch/zoom switch
By default,
LAUNCH
and
ZOOM
modes are selected via switch SE. You can use a different switch by altering the settings
in the table below.
A single 3-position switch must be used.
In the third (unassigned) position, the main flight mode
switch will be active (§7.2).
Menu point
Setting
Default
FLIGHTMODES
LAUNCH
(FM2)
Sw3pos
(↑↓ or -)
SE↓
FLIGHTMODES
SPEED
(FM3)
Sw3pos
(↑↓ or -)
SE-
7.2
Main flight mode switch
By default,
THERMAL
,
SPEED
and
CRUISE
modes are selected via switch SA. You can use a different switch by altering the
switch settings for
THERMAL
and
SPEED
modes. A
single 3-position switch
must be used. The third (unassigned) switch
position selects
CRUISE
mode.
Menu point
Setting
Default
FLIGHTMODES
THERMAL
(FM6)
Sw3pos
(↑↓ or -)
SA↓
FLIGHTMODES
SPEED
(FM7)
Sw3pos
(↑↓ or -)
SA↑
7.3
Changing cal sub-mode switch
By default, the CAL sub-modes are selected via switch SA. You can use a different switch by altering three logical
switches as shown below. A
single 3-position switch
should be used for all sub modes.
Menu point
Setting
Default
LOGICAL SWITCH
L7
2
nd
param
Sw3pos
↑
SA↑
LOGICAL SWITCH
L8
2
nd
param
Sw3pos
-
SA-
LOGICAL SWITCH
L9
2
nd
param
Sw3pos
↓
SA↓
