The fan and ventilation openings are responsible for cooling the amplifier when it is in
use, so it cannot be obstructed.
CAUTION
1 - INPUT:
Inputs of signals to be amplified. Connect these signals to RCA outputs of CD/DVD Player, using
good quality shielded cables to avoid noise interference.
2 - THRU OUT:
This output can send the same input signal (INPUT) to another amplifier.
9 - SPEAKER:
Output (positive and negative) to transducer’s connection (loudspeakers). Follow the
polarity described and the minimum impedance recommended.
To combine loudspeakers, the resulting impedance must be taken into consideration.
3 - LEVEL:
It sets the amplifier input sensitivity, which allows an optimal adjustment to the output signals
levels of nearly all models of CD/DVD Players found in the market.
5 - LOW PASS:
Variable adjustment from 60Hz to 250Hz, which determines the end of the amplifier
operating frequency.
6 - FREQ.
Set the Bass Boost center frequency, from 35Hz up to 60Hz.
7 - BASS BOOST:
Boost the bass signals with variable range of 0 to + 12dB.
8 - REMOTE TERMINAL:
The remote CD/DVD Player output must be connected by a 0.75 mm² (18 AWG)
cable.
4 - SUBSONIC:
Variable adjustment from 8Hz to 30Hz, which determines the beginning of the amplifier
operating frequency.
10 - FANS:
The BASS 30K, has four internal ventilation fans, and cannot be blocked. For perfect
functioning, the amplifier must be installed in a cool and aired place. It is recommended not to embed it,
so that the air circulates throughout the inside of the product extension, thereby preventing the thermal
protection from acting.
Functions, inputs & outputs
2 OHMS
2 OHMS
Resulting
impedance:
1 OHM
09
THRU OUT
INPUT
REM
LPF
SUBSONIC
LEVEL
30
8
250
60
0
MAX
Hz
Hz
CROSSOVER
BASS BOOST
SPEAKER
SPEAKER
250
Due to the presence of voltage at the output terminals when the product is turned on,
avoid contact with them. Risk of electric shock.
CAUTION
