The fan and ventilation openings are responsible for cooling the amplifier when it is in
use, so it cannot be obstructed.
CAUTION
Functions, inputs & outputs
8 - REMOTE TERMINAL:
The remote CD/DVD Player output must be connected by a 0.75 mm² (18 AWG)
cable.
To combine loudspeakers, the resulting impedance must be taken into consideration.
3 - LEVEL:
It sets the amplifier input sensitivity, which allows an optimal adjustment to the output signals
levels of nearly all models of CD/DVD Players found in the market.
5 - LOW PASS:
Variable adjustment from 60Hz to 250Hz, which determines the end of the amplifier
operating frequency.
9 - SPEAKER:
Output (positive and negative) to transducer’s connection (loudspeakers). Follow the
polarity described and the minimum impedance recommended.
2 - THRU OUT:
This output can send the same input signal (INPUT) to another amplifier.
7 - BASS BOOST:
Boost the bass signals with variable range of 0 to + 12dB.
6 - FREQ.
Set the Bass Boost center frequency, from 35Hz up to 60Hz.
1 - INPUT:
Inputs of signals to be amplified. Connect these signals to RCA outputs of CD / DVD Player,
using good quality shielded cables to avoid noise interference.
10 - FANS:
The BASS 15K, has four internal ventilation fans, and cannot be blocked. For perfect
functioning, the amplifier must be installed in a cool and aired place. It is recommended not to embed it,
so that the air circulates throughout the inside of the product extension, thereby preventing the thermal
protection from acting.
4 - SUBSONIC:
Variable adjustment from 8Hz to 30Hz, which determines the beginning of the amplifier
operating frequency.
2
OHMS
2
OHMS
Resulting
impedance:
1 OHM
THRU OUT
INPUT
SPEAKER
REMOTE
LPF
FREQ.
BOOST
SUBSONIC
LEVEL
30
8
250
60
+10
60
35
0
0
MAX
dB
Hz
Hz
Hz
CROSSOVER
BASS BOOST
1
8
7
2
5
4
3
6
9
10
10
09
Due to the presence of voltage at the output terminals when the product is turned on,
avoid contact with them. Risk of electric shock.
CAUTION
