Tar River DRL-072, Operator'S Manual

Page: 10 / 38

10
Assembly
1. Support frame a few feet above floor with blocks or a
Tar River Implement handler.
2. Bolt on coulter assemblies using the U - bolts closed
end facing the three point, using the last two bars. Off
set the drills as evenly as possible 5 on one bar 5 on the
next bar.
3. Screw one red cup to each side of each spring, fold the
spring as evenly as possible and cut the spring in the
middle using side cuts. Until you have a total of 20
cups with springs.
4. Flip spreader box upside down before installing, install
each of the cups to the feed hole using a cotter pin,
place a washer on the loop side of cotter pin before in-
stalling. (Use the last hole on the feed side).
5. Install RED shut off flap into each seed cup.
6. With assistance carefully lift and flip spreader box on the frame. (make sure cleanout lever
is towards rear). Using copper colored bolts install bolt and nuts use a washer on both sides
of the box, DON ’ T TIGHTEN.
CLEAN OUT LEVER
8