Tapworks TWHF, Installation And Operation Manual, Page: 8 / 12

7
Programming the Electronic Controller
Controller settings required
Upon installation, and after an extended power outage. When the transformer is
plugged into the electrical outlet, a model code (LCF) and a test number (example:
J1.6), are briefly shown in the faceplate display. Then the words “SET TIME”
appear and “12:00” begins to flash.
NOTE: If “- - - -” shows in the display, press the UP or DOWN button until
the model code (AF) shows in the display. Then, press the ENTER button
to set, and change to the flashing “SET TIME" display.
Set present time of day
If the words “SET TIME" do not show in the display, press the ENTER button
several times until they do.
1. Press the UP or DOWN buttons to set the present time. Up moves the
display ahead; down sets the time back.
NOTE: Press buttons and quickly release to slowly advance the display. Hold
the buttons down for fast advance.
2. When the correct time is displayed, press the ENTER button several times, until
the time appears on the display, but is not flashing.
Start a clean rinse cycle
To manually start a Clean Rinse cycle, press and hold the CLEAN button for a
few seconds, until “RECHARGE NOW” flashes in the display. This Clean Rinse
cycle takes 3 minutes (unless the factory settings for backwash and fast rinse times
have been changed, as shown on the following page).