WSPR Without Tears
With any luck, the display will look something like Figure 6: WSPR Locater. Look for the line starting
with
eth0
. The line below it shows
inet addr: 192.168.1.210
. Your setup should be similar except for
the last two numbers (it will begin with 192.168, but the last two numbers will probably be different).
Record the full number (
192.168.aaa.bbb –
aaa and bbb are the numbers for your Pi) for the next step.
That's the IP address of your Pi. If the program fails to find the Pi, try it again. If that fails, go to the
Troubleshooting section.
Note: The first time you run WSPR_Locater
inet addr
will be displayed for
eth0
, the Ethernet
connection. After setting the WiFi portion of the WSPR configuration (see Figure 7: WSPR
Configuration Screen), WSPR_Locater will display
inet addr
for
eth0
if the Ethernet cable is still
connected and
inet addr
for
wlan0
, the WiFi connection.
TAPR (c) 2018-2019 “WSPR Without Tears” 9 Of 20 Version 2.1 05/20/2019
Figure 6: WSPR Locater