In order for this dishwasher to work, the following are required:
.
• COLD WATER SUPPLY
.
• DRAINAGE FOR USED WATER
.
• ELECTRICITY: 115 VOLT, 60Hz Outlet
. •
GROUNDING
.
• HORIZONTAL FLAT SURFACE
Note:
For your convenience, the water inlet hose and drain hose are preinstalled to the dishwasher
from the factory. Both hoses are located behind the dishwasher at the left bottom of the
dishwasher.
1.
1. You dishwasher must be placed on horizontal flat surface near by the sink on the kitchen bench
(countertop). Placing the dishwasher as near to a sink as possible to allow for proper installation of the water
inlet and drainage hoses.
2.
2. Connect the other end of water inlet hose to the cold water faucet.
(Quick Connect Sink Adapter is supplied)
1.
3. The other end of the drain hose must be placed properly in the sink or at yourdrain outlet in order
to let used water drained out from the dishwasher.
2.
4. Plug in the dishwasher to a regular 115 Volt / 60 Hz, 15 Amp. Outlet.
Note:
This figure is for illustration purpose only.
Drain Hose
Note:
Inspect carefully for any water leak around and back of the machine. If any leak occurs, double check
to see if any connections are loose. You may need to tighten any loose connections.
Understanding the Drain Hose Hook Up:
.
• Your dishwasher is equipped with a gravity drain system. The drain hose should be positioned
above the drain in order to drain properly.
.
• If the drain hose is bent or shrunken, it may affect water draining.
.
• If water cannot be drained out smoothly, the dishwasher operation will be disturbed and it may
stop in the middle of the cycle.
18
