17
Step 6
-
Route the cable(s) to the control
unit. The cable(s) should exit from the
edging as close to the control unit
position as possible. The cables should
be protected in suitable conduit between
the edging and the control unit. Protect
any edges over which the cables pass
with grommet strip or similar.
Step 7
-
Fit the cover extrusion of the
edging
using
suitable
self
-
tapping
screws.
SEE FIGURE 17
SEE FIGURE 17
Figure 15
-
Connection of sensors in series
Figure 16
-
Wiring of two mat sensors each with 2 x 2 core cables
GREASE
-
FILLED
TERMINALS
NOTE: CONNECT THE CABLES
COLOUR TO COLOUR USING THE
GREASE
-
FILLED TERMINALS
MAT SENSOR
MAT SENSOR
