S n a p S t a n d
M X S e r i e s
™
6
MX Stand
™
Set-up
STEP 1
Attach Stand Counter Balance Brackets to
Plank with Carriage Bolts and Nylock Nuts
using a 7/16" Socket or Open end Wrench.
Counter Balance is required for operation.
Stand Counter
Balance Bracket
Stand Counter
Balance Plank
Hardware Requirements: (2) 7/16" & (2) 9/16" Open end wrench.
Right Stand
Leg Assembly
Left Stand
Leg Assembly
3/8-16 x 2 3/4" Hex Hd Bolt
3/8" Flat Washer
3/8" Lock Washer
3/8" Nylock Nut
STEP 2
Slide Stand Counter Balance Assembly up
to the Stand Legs. Insert the 3/8-16 x 2 3/4"
Hex Bolts through the Stand Counter Bal-
ance Bracket and Leg as shown in Figure
2. Use a 9/16" wrench to tighten down 3/8-
16 Nylock Nut.
STEP 3
Insert Front Support Tube through both
Right and Left Legs as shown in Figure 3.
Next slide the 1/4-20 x 2 1/2" bolt through
the Stand Leg and Support tube. Use the
7/16" wrench to secure the Support Tube
in place with 1/4-20 Nylock Nuts.
1/4-20 x 3/4" Carriage Bolt &
1/4-20 Nylock Nut
Stand Counter
Balance Assembly
