11
Lonely? Looking for that special someone? Do you have a question about
your TAPCO loudspeaker?
Please call our Technical Support chaps at
1-877-87-669
, Monday to Friday, from 7 AM to 5 PM PST.
After hours, visit www.tapcoworld.com and look under
Support
, or e-mail us at [email protected]
voice coils slowly by sending a low-level signal
through them for about 15 minutes prior to high-
power operation.
• Use a damp cloth with a mild soap solution to
clean the cabinets. Avoid getting moisture into
any of the openings of the cabinet, particularly
where the drivers are located.
Flash From The Past
“Good morning. What we have in mind is breakfast in bed for 400,000!”
– Wavy Gravy at the Woodstock Festival & Concert, 1969
Care and Maintenance
Your TAPCO loudspeakers will provide many years
of reliable service if you follow these simple guidelines:
• Avoid exposing the loudspeakers to moisture. If
they are set up outdoors, be sure they are under
cover if you expect rain.
• Avoid exposure to extreme cold (below
freezing temperatures). If you must operate the
loudspeakers in a cold environment, warm up the
COLD
HOT
1+
1+
1–
1–
2–
2+
Appendix B: Connections
Use heavy gauge, stranded wire for connecting
a speaker to the output of a power amplifier.
Do not
use a guitar cord to make this connection.
They
aren’t designed to handle the high currents produced
by a power amplifier and can overheat.
As the distance between the amplifier and
speakers increases, the thickness of the wire should
also increase. Speaker wire has resistance, and when
electricity passes through a resistor, power is lost. The
thicker the wire, the less resistance it offers, and the
more power actually gets to the speaker.
1/4" TS Phone Plugs and Jacks
“TS” stands for Tip-Sleeve, the two connections
available on a mono 1/4" phone jack or plug.
They are used for unbalanced signals and speaker
connections.
1/4" TS Wiring:
Sleeve = Cold (–)
Tip = Hot (+)
NL4-Type Plugs and Jacks
This connector is compatible with the popular
Neutrik® Speakon® 4-pole plugs. These connectors
are designed to handle the higher currents produced
by amplifiers, and have a locking feature to prevent
accidental disconnections. Simply line up the tabs
on the plug with the jack on the Series 69 connector
panel, push it in, and rotate it 1/4 turn to the right to
lock it in place.
NL4 Wiring:
Pin 1 – = Cold (–)
Pin 1 + = Hot (+)
Pin 2 – = No Connection
Pin 2 + = No Connection
SLEEVE
TIP
TIP
SLEEVE
TIP
SLEEVE
