The Taoglas Raptor III is an external combination antenna designed
for mounting on the roof of a vehicle. The Raptor III can accomodatea
combination of up to 7 antennas in one sleek housing. One 22mm(0.86”)
hole is required when installing this antenna. The cables are fed through this
hole and secures the antenna to the surface with nut and washer.
The Raptor III is IP67 waterproof rated and includes a rubber base to provide
a seal against water ingress.
Raptor III Series
7-in-1 Permanent Mount Combination Antenna
Installation Instructions
A
Introduction
B
Mounting & Location
The Raptor III can be mounted on any surface, without the need for a ground
plane. When mounting on a vehicle roof panel ensure to mount on a flat
surface. When mounting the Raptor III, it should be placed as far as possible
away from other roof-mounted features such as the aircon unit, light bar etc.
Electrical Safety
The Raptor III MA1270 contains an active GPS/GNSS antenna.
Rated voltage: 3-5VDC Rated current: 24mA maximum
The supply to this device must be provided with over-current protection of 1A maximum.
Power [email protected] (mA) 4.5 mA
Power [email protected] (mA) 10 mA
Power [email protected] (mA) 24 mA
Sealing
In order to ensure that the installation is sealed against the mounting surface care must
be taken regarding curvature of the mounting panel. It is highly recommended to install
the antenna on a clean, flat and level surface. After installation the compression of the
rubber boot against the mounting panel should be checked and a small bead of neutral
cure silicone sealant can be applied around the periphery of the base of the antenna
if required.
Mount on a flat surface
Raptor III/IG-20-8-005
www.taoglas.com
Hole
Ø
C
Mounting Hole
When preparing to drill the hole, mask the area around the hole position to
protect the surface. Drill a pilot hole through the panel and increase the hole
size to 22mm(0.86”) diameter. Ensure the drill bit does not contact the headliner.
Deburr and clean the area around the hole carefully removing all waste. Remove
paint and primer from under panel surface to ensure adequate earth contact by
washer and nut. Apply petroleum jelly or paint around cut edge of the hole to
prevent corrosion
22mm
