IG-21-8-017-A
www.taoglas.com
Unscrew the split steel nut from the antenna body and
slide the the coaxial cable out through nut and washer.
Determine where the antenna is to be mounted, please
ensure this is a flat surface. Drill a 16mm [5/8” ] diameter
hole.
Note: Min panel thickness 4mm [5/32in], Max panel
Permanent Mounting
Route the coaxial cables through the hole in the panel.
Align the antenna properly and press down to secure
the adhesive base in place.
Note: Avoid sharp bends when routing coaxial cable.
Ensure the mouting surface is clean and all debris,
dust, or any other contaminant is removed. Remove the
protective liner from the pre-installed base adhesive on
the antenna.
Note: Once exposed, avoid touching the adhesive.
Completed Installation.
Insert the coaxial cables through the washer and steel
nut and slide them upwards. Tighten to secure the
antenna in place. Ensure the nut is fully tightened.