![TANSEL SL.450.H Manual Download Page 1](http://html.mh-extra.com/html/tansel/sl-450-h/sl-450-h_manual_818099001.webp)
HOW TO INSTALL
BATTENS
BATTENS
BATTENS
BATTENS
USING 2 x 13mmW SLIDES
BATTEN PLACEMENT
Battens can be used on one side or both. They are placed between the cabinet wall and slide.
STEP 1: SEPARATE SLIDE MEMBERS
STEP 2: MARK & DRILL BATTEN HOLES
BEFORE YOU BEGIN
Place batten, slides and basket into position to ensure you have the correct fit and the slides clear the door obstruction.
A small gap (up to 5mm) is fine if you are using slides with hooks (product code SL.450 or SLB.450).
These instructions are applicable for any thickness of batten.
The standard screws supplied with basket are 16mm length. Depending on the batten thickness and if you are using any other spacers, we suggest:
-
If using 11mm batten, 8G x 25mm counter, phillips head countersunk or pan head
-
If using 16mm batten, 8G x 30mm counter, phillips head countersunk or pan head
-
If using 18mm batten, 8G x 30mm counter, phillips head countersunk or pan head
LHS
Turn the slides over & extend them fully until you can see the black
disconnect lever. Pinch it in the direction of the arrow. This will
release the slide members.
Single side
Both sides
LHS
A) Draw a center line through the batten and mark the holes as pictured. These
holes are compatible with the 2 x 13mmW slides. If you’ve been supplied a
different slide, place your slide on the pencil centre line and mark accordingly.
TIP: You can drill holes straight through the batten and use one longer screw to
join the slide & batten to the cabinet wall. If you plan to screw batten first (and
then the slides) we suggest you counter sink the screw.
FRONT
287
425
23