background image

2

NEW ZEALAND

For further assistance call our free phone number 0800 852 258

or consult our website www.fit

-nz.co.nz 

•  If your cabinet is made to suit the minimum internal sizes the bin 

frame will fit snugly in the cabinet and allow easy installation. 
These dimensions can be found on our website on each product’s 
Download Brochure link.

•  If your cabinet width is greater than the minimum internal width 

and you are mounting a drawer front then you need to centralise 
the bin frame in the cabinet.

•  If you’re fitting a handle type, you need to fix to the opposite side 

of the cabinet to the door hinges or a minimum of 25mm from 
hinged side of cabinet.

NOTE:  Please refer to Tanova Waste Solutions catalogue for internal dimensions.

1.

 

With your cabinet upside down (fig.1) position the bin frame as shown 
with a minimum clearance of 2mm back from cabinet front (fig.2).

NOTE: If the system is a 
Push to Open unit, 5mm 
of clearance must be 
maintained between 
back of drawer front and 
cabinet (including bump 
stops if fitted).
Bringing assembly flush 
with the front of the 
cabinet will achieve this.

Fig. 1

Fig. 2
IMPORTANT: Minimum 
clearance  of 2mm from  
the front of the cabinet.

2mm

Summary of Contents for TB

Page 1: ...ll TB Models Handle and Drawer Types Installation Guide Your Handy Step By Step For further assistance in New Zealand www tanova co nz 0800 852 258 For further assistance in Australia www tanova com au 1300 123 700 ...

Page 2: ...in the cabinet If you re fitting a handle type you need to fix to the opposite side of the cabinet to the door hinges or a minimum of 25mm from hinged side of cabinet NOTE Please refer to Tanova Waste Solutions catalogue for internal dimensions 1 With your cabinet upside down fig 1 position the bin frame as shown with a minimum clearance of 2mm back from cabinet front fig 2 NOTE If the system is a...

Page 3: ...e buckets into the bin carriage and you are done 4 If you have a set of marking jigs go to step 5 If not measure off the fixing points and mark on back of door then go to step 6 5 To mount your drawer front with marking jigs insert the jigs as shown below and position your front panel then give the front a bump wit your hand to mark the screw positions on the reverse side of the door fig 5 Fig 3 S...

Page 4: ...ews 8 Check alignment again and adjust 9 Now fasten the two remaining screws into lock off points to prevent drawer front movement 10 Insert bins and you re ready to go 11 Bags can be fitted optional just raise handles and place bag liner in bin and around the rim now lower handles to hold bag open and firmly in place For further assistance in New Zealand www tanova co nz 0800 852 258 For further ...

Reviews: